LED panel light is a high-grade indoor lighting, its outer border is made of aluminum alloy by anodic oxidation, the light source is LED, the whole light design is beautiful and simple, the atmosphere is luxurious, both good lighting effect, and can bring the feeling of beauty to people.
LED panel design is unique, light through the high transmittance of the light guide plate after the formation of a uniform plane luminous effect, illumination uniformity is good, the light is soft, comfortable and bright, can effectively relieve eye fatigue. panel led lights also protect against radiation and do not irritate the skin of pregnant women, the elderly and children. So, PANEL LED LIGHT is very suitable for replacing traditional lighting such as incandescent lamp and fluorescent lamp.
From the perspective of structure, PANEL LED lights can be divided into two categories, which are LED backlit panel light and LED edge-lit panel light.
Backlight panel light is to use LED light Angle to do a reasonable LED spacing design, with the diffusion plate and the height of the light to achieve the ideal light mixing effect. Focus on high brightness, 595*595 specification can reach 4000lm, high efficiency products, replace the traditional grid light. Thicker, usually up to 35mm thick. The light is more uniform, the brightness uniformity can reach above 0.9. The process requirements are relatively simple.
The side luminescent panel light is designed according to the arrangement of LED panel light beads and the luminescent Angle of LED beads by using the light guiding panel technology, so that the light can be evenly distributed through the light guiding panel. The brightness is low, generally within 3000lm with the specification of 595*595; Can be used in part of the ceiling lower occasions. Relatively thin, the thickness is within 9mm. The surface uniformity is poor, the highest brightness uniformity reached 0.9, if the treatment is not good, there will be a more obvious bright edge. The cleanliness of the workshop is required to be high, the process control is not good, the yield is low (mainly caused by dust in the light guide plate).