When installing LED panel lights, wiring shall be as shown in the drawing: red line shall be connected with live wire, and green line shall be connected with zero wire; Red line, green line is forbidden to add switch! Pile head under yellow wire switch (power off side); Switch on the pile head (caller side) with the red line fire line!
The switch is only controlled for normal lighting, LED panel light is not controlled for emergency lighting. Do not turn off the red line when the yellow line power, this state should be easy to damage LED purification panel light emergency power supply device! Must be charged 24 hours before use, emergency is strictly prohibited no-load (no light source) state!
LED panel light is a kind of lighting fixture, suitable for installation in various indoor places such as supermarket, school classroom, office, food factory and hospital.
JAMSEM LED panel light
LED panel light, good anti-corrosive performance, not easy to wear and fade. The accessories of LED panel lighting adopt flame retardant material, which has certain fire resistance.
If there are special requirements for the fire performance of LED panel lights, TPA fire panel lights produced by JAMSEM can be selected.
LED purification light is a kind of LED panel lamp, which is generally used in FFU clean room. Such clean room generally has a grade of 100 or above, and most of them are electronic workshop. Such workshop usually requires yellow LED panel light, such as photolithography room.
LED purification panel lights are widely used in medicine, health, biology, food, chemical industry, electronics, scientific research and other fields with high requirements and high standards.
LED purification panel light emergency power will automatically charge, discharge, without special monitoring. There is a certain service life, discharge cycle cycle is scrapped, generally 500 times, so as far as possible to avoid the phenomenon of artificial power failure.
